Speaker set up
Product Support & Setup Guides
For all Shinjitsu Audio speakers
Easy set up instructions
Step 1
Place the horn on top of the black cradle
Seat the horn magnet in the rear plinth cradle
Place the horn throat on the front support
Step 2
Attach the silver horn leads to the horn
Connect the horn leads to the top terminals
Red to Red and Black to Black
Step 3
Connect the resistor to the top posts
Push each plug firmly into the sockets
Bridge the posts with the resistor
Step 4
Adjust the horn volume with the resistor
Higher resistor values make it louder
Lower resistor values make it quieter
Step 5
Plug the rear speaker terminals into your amplifier
The top terminals are for the horn only - do NOT connect these to an amplifier
The horn will not function without the resistor
Download instructions and integration guides for all current products below.
Speaker stands set up
Insert legs and align as shown. Insure to not over torque to avoid stripping screws
Horn X2: Crossover & Sensitivity Calculator
Use this tool to explore how capacitor and resistor choices affect crossover point and horn sensitivity.
Crossover Frequency: - Hz
Resulting Sensitivity: - dB
Shinjitsu Full Speakers: Sensitivity Tuner
Adjust parallel resistor only. Use this for complete Shinjitsu Audio speakers — not Horn X2 modules.
Resulting Sensitivity: - dB
Based on default horn output of 109 dB before attenuation.